
Door prepared for a smart lock in Botany Downs
Accurate drilling and alignment prepared this metal-framed entry door for a modern smart lock installation.
Read the job →24/7 emergency locksmith · 20 years · Auckland wide
From the vans
Every job below actually happened somewhere in Auckland. We write them up because the fix is usually useful to the next person with the same problem.

Accurate drilling and alignment prepared this metal-framed entry door for a modern smart lock installation.
Read the job →
A full-width view of the roller door showed why the centre lock and both horizontal bars needed to be adjusted together.
Read the job →
A worn garage-door T-handle was replaced and tested with the internal locking linkage before the door went back into daily use.
Read the job →
Old hardware had left several openings in this timber door, requiring accurate preparation before the new Lockwood lock could be fitted.
Read the job →
A tired deadbolt was replaced before its worn keyway could turn into a complete lockout.
Read the job →
The keyway and handle mechanism on this older timber door had failed after years of wear.
Read the job →
An Orion GRID Connect lever lock gave this Flat Bush property a modern keyless entry option with a familiar handle format.
Read the job →
The keypad on this compact safe was no longer giving access, so the lock and override system needed a careful check.
Read the job →
An older Chubb safe on a commercial site needed specialist assessment when its normal access method was no longer available.
Read the job →
The Dorma mortice case came out of the door for a proper inspection after the latch became unreliable.
Read the job →
A high-use apartment lock had become difficult to operate and needed careful servicing around the existing door furniture.
Read the job →
The old keyed lever had failed internally, so we matched a clean satin replacement to the existing door preparation.
Read the job →
A tired surface-mounted deadlatch was removed and a replacement prepared for a busy Kingsland entry door.
Read the job →
The centre lock on this workshop shutter had become stiff and the side bars were no longer travelling evenly.
Read the job →
A clean matching deadbolt and lever installation gave this dark timber entry door separate security and everyday latch control.
Read the job →
A dusty, high-use roller door lock needed servicing before the key mechanism failed completely.
Read the job →
An older glazed timber door had lost part of its lock hardware and needed a practical repair around the existing openings.
Read the job →
A recessed pull and lock on an aluminium slider was no longer engaging consistently and needed adjustment inside the stile.
Read the job →
The old deadbolt was stripped from the door and replaced with a clean, correctly aligned unit.
Read the job →
A tired cylinder in an aluminium glazed door was replaced without disturbing the surrounding joinery.
Read the job →
A lever handle that had shifted out of line was dismantled and reset before it damaged the latch inside the door.
Read the job →
The old lock had failed and left damage around the opening, so the door needed careful preparation before a secure replacement could go in.
Read the job →
A close look inside a tired rim cylinder before the faulty parts were replaced and the lock returned to service.
Read the job →
About one in four Auckland pools fails its first council safety inspection — and the gate latch is the most common reason. What the council checks, and how we put it right.
Read the job →
Keyless entry on a timber front door in St Heliers — a Yale smart lock with PIN codes, swipe cards and a mechanical key override for backup.
Read the job →
New deadbolt and knobset on a Mount Eden flat door — keyed alike so one key does everything, and the landlord has a proper record of who holds keys.
Read the job →
A heritage cedar door on a Grey Lynn villa needed modern access without ruining the look — a BioSecure fingerprint lock was the answer.
Read the job →
An early digital lock on its last legs, and a clean upgrade to fingerprint, PIN and key access. A straight swap on an Epsom front door.
Read the job →
Street-front gate on a Ponsonby townhouse, secured with a Yale digital lock — PIN entry from outside, one-touch exit from inside.
Read the job →
A mechanical combination bolt on an Onehunga side gate — no keys, no batteries, and the tradies get a code instead of a key they never return.
Read the job →
A sliding patio door in Pakuranga that hadn't locked properly in months — new keyed mortice lock, serviced rollers, done in one visit.
Read the job →
Salt air near Takapuna beach had destroyed two electronic gate locks in three years. The fix: a fully mechanical combination bolt with nothing to corrode.
Read the job →
Lost bag, lost keys, address inside. A Papatoetoe house rekeyed the same afternoon — every cylinder re-pinned on the bench in the van.
Read the job →
A Yale mortice lock in a Henderson aluminium door stopped throwing its bolt. We stripped and repaired the mechanism in the van rather than replacing the whole unit.
Read the job →
A high-traffic door at a Newmarket childcare centre that wouldn't stay latched — new heavy-duty latch fitted between sessions.
Read the job →
One key, one busy worksite, and a ute that had to move by lunchtime. A roadside all-keys-lost job in Manukau.
Read the job →
A southerly gust, a slammed villa door, and a 1930s mortice lock that had never been picked. Central Auckland after-hours callout.
Read the job →
Four doors, four different keys, and an unknown number of copies out in the world. A settlement-week rekey on the Shore.
Read the job →
The dealer said the import was not on their system. We had it running from a new key inside two hours in Henderson.
Read the job →
Restricted keys, a body corporate policy and an 11pm lockout. What actually happens on an apartment callout.
Read the job →
Forty staff, eleven doors, and a bucket of unnumbered keys in the office. A proper key hierarchy for an East Tamaki site.
Read the job →
Five businesses sharing one front door and nobody wanting to be the keyholder. A fob system solved it in a day.
Read the job →
A jemmied back door, a family who could not sleep, and an insurance claim that needed proper documentation.
Read the job →
Engine running, doors locked, groceries melting. A ten-minute car park rescue in Botany.
Read the job →
Kids who lose keys, a cleaner who needs Thursday access, and a door that still has to work in a power cut.
Read the job →
Ten years of harbour salt, one seized slider lock, and a homeowner about to force it into a much bigger repair.
Read the job →
The online fob was the wrong frequency. A cautionary tale about cheap listings, from a Glenfield driveway.
Read the job →
5:10am, a jammed shopfront lock, and a cafe due to open in fifty minutes.
Read the job →
A quiet clause in a home policy, three doors with only a latch, and a fix that took one afternoon.
Read the job →
Six utes, six single keys, one very exposed business. A morning of preventive key work in Papatoetoe.
Read the job →
Two days between tenants, keys unaccounted for, and RTA obligations to meet. A standard changeover done properly.
Read the job →
Level 14, no building manager until 8am, and a resident in the lobby at 3am. A CBD after-hours job.
Read the job →
Wet togs, two kids, and a set of keys visible on the driver's seat. Sunday afternoon in Howick.
Read the job →Most of these jobs were solved in a single visit. Call and we will tell you what yours needs.
Open 24 hours · Including public holidays